Posted April 19, 2021
TRAFFIC ALERT
TRAFFIC SIGNAL IMPROVEMENT PROJECT
BROADWAY AND SWAN ROAD INTERSECTION
On Thursday, April 22, 2021, crews from Next Generation Electrical, under contract with the City of Tucson Department of Transportation and Mobility (DTM), are scheduled to remove and replace the traffic signal heads onto the newly installed poles, as well as convert the traffic signals to include flashing yellow arrows, at the Broadway and Swan Road intersection.
Last Friday, April 16, crews installed new traffic signal poles and mast arms at the same intersection.
Work will take place from about 7 a.m. to 4 p.m., the same day. The schedule is subject to change due to inclement weather or unforeseen circumstances.
During work, the traffic signals will not be in operation and travel lane restrictions will be in place at the intersection. Travel on Broadway will be reduced to two lanes in each direction, and travel on Swan Road will be reduced to one lane in each direction. Turning movements will not be affected by this work.
Law enforcement officers will be on site to direct travel through the intersection until the work is complete. The traveling public can expect delays when driving in the work area. Please obey all traffic control signs and watch for law enforcement officers and construction personnel in the area.
DTM is upgrading intersections throughout the community with flashing yellow left turn arrows to improve safety. Research has indicated that left turn collisions are reduced with flashing yellow arrows. The conversion to flashing yellow arrows also provides operational flexibility; during certain times of the day, left turns can be prohibited unless there is a green arrow. Also, when pedestrians want to cross parallel to traffic, left turning traffic can be stopped with a red arrow until the pedestrian has safely crossed the intersection.
During a flashing left turn arrow, motorists should yield to pedestrians, oncoming motorists and bicyclists and proceed with caution when turning left.
ALERTA DE TRAFICO
PROYECTO DE MEJORA DE SEMAFORO
INTERSECCION BROADWAY Y SWAN ROAD
El jueves 22 de abril de 2021, los equipos de Next Generation Electrical, bajo contrato con el Departamento de Transporte y Movilidad (DTM) de la Ciudad de Tucson, están programados para remover y reemplazar los semáforos en los postes recién instalados, así como para instalar flechas amarillas intermitentes en el semáforos, en la intersección de Broadway y Swan Road.
El pasado viernes 16 de abril, las cuadrillas instalaron nuevos postes y brazos en el semáforo de la misma intersección.
El trabajo se llevará a cabo aproximadamente de 7 a.m. a 4 p.m., el mismo día. El horario está sujeto a cambios debido a las inclemencias del tiempo o circunstancias imprevistas.
Durante el trabajo, el semáforo no estará en funcionamiento y habrá restricciones en los carriles de circulación. La circulación por Broadway se reducirá a dos carriles en cada dirección y la circulación por Swan Road se reducirá a un carril en cada dirección. Los movimientos de vuelta no se verán afectados por este trabajo.
Agentes de la ley estarán presentes para dirigir los movimientos a través de la intersección hasta que se complete el trabajo. El público que viaja puede esperar retrasos al conducir en el área de trabajo. Obedezca todas las señales de control de tráfico y esté atento a los agentes de la ley y al personal de construcción en el área.
DTM está mejorando las intersecciones en toda la comunidad con flechas amarillas intermitentes de vuelta a la izquierda para mejorar la seguridad. Estudios han indicado que los accidentes de vuelta a la izquierda se reducen con flechas amarillas intermitentes. La conversión a flechas amarillas intermitentes también proporciona flexibilidad operativa; durante ciertos periodos del día, se puede prohibir dar vuelta a la izquierda a menos que haya una flecha verde. Además, cuando los peatones quieran cruzar en paralelo al tráfico, el tráfico que da vuelta a la izquierda se puede detener con una flecha roja hasta que el peatón haya cruzado la intersección de manera segura.
Durante una flecha de vuelta a la izquierda intermitente, los automovilistas deben ceder el paso a los peatones, los vehículos y los ciclistas y proceder con precaución al dar vuelta a la izquierda.